Self-adhesive velvet sheet protecting the floor and board against damage.
Sheet for independent application on the GAKKER board.
Instruction for application of self-adhesive velvet sheet - Velvet Cover from GAKKER
a) check if the self-adhesive velvet sheet - Velvet Cover you have fits in shape to your version of the GAKKER board: place the sheet on the convex side of the board (there should be a 5-10 mm space between the sheet and longer edges and a space of about 5 mm between shorter edges),
b) prepare the board - it should be clean, dry and degreased,
c) prepare a ruler or other similar object.
Peel off the protective paper on the short side of the edge along the section of about 3-4 cm.
Start applying the sheet from the short edge keeping necessary distances from all edges.
Peel off gradually the protective paper and apply the velvet cover to the board at the same time.
While applying the sheet make sure that there are no air bubbles under the velvet cover and the material is applied equally in relation to the board edges. The ruler can be used for the uniform application and simultaneous removal of air bubbles.
In case of dirt use a soft and slightly damp cloth. For coarse dirt you can use a gentle detergent. The board should not be excessively wetted out. In case of dirt, such as dust or crumbs you can use a vacuum cleaner or clothes cleaning roll.
The board with the applied velvet cover is not intended for children under the age of three.
The velvet cover protects your board and floor if the board is used the convex side down, in other situations the velvet cover does not guarantee protection.
The board with the applied velvet cover is not subject to consumer return.